Pigtronix Infinity Looper - Manual (Page 21)

CHAPTER 3. INFINITY RULES 20
3.8 Sync Multi
For basic Sync Multi functionality see the Sync Multi Section (page
10)
Holding the Sync Multi switch will toggle Sync Multi on or off.
Quickly pressing the Sync Multi switch once Sync Multi is on, cycles
through the sync multiplier factor.
When Sync Multi is turned off, the lengths of Loop 1 and 2 are un-
related and playback is unsynchronized. If Loop 2 is recorded when
Sync Multi is off, it cannot be turned off until Loop 2 is erased.
The multiplier displayed on the LED bar to the right of the Sync Multi
switch determines the length of Loop 2 relative to Loop 1. At x1, the
lengths of Loop 1 and Loop 2 are identical, and they begin and end
at the same points. At x2, Loop 2 is double the length of Loop 2.
Etc.
When Multi Sync is on and the Loop 2 footswitch has been pressed,
recording on Loop 2 will automatically begin at the start of the next
Loop 1 cycle, and close after the selected number of cycles.
3.9 Series Loops
When Series is on, only one of the two loops can be played back at
any given time.
When Series is on, enabling playback or recording on a loop will im-
mediately stop playback of the previously selected loop, closing any
overdub that was in progress.
In Series mode, when recording on Loop 1, pressing the Loop 2