Pigtronix Infinity Looper - Manual (Page 18)

3. Infinity Rules
3.1 Arm
Arming a loop is achieved by pressing the footswitch that corresponds
to the desired loop. The Arm light above the selected loop will glow
red indicating its status as armed. A loop must be armed in order
to accept further commands. When the Infinity powers up initially,
LOOP 1 is armed by default. Loop 2 cannot be armed until material
is recorded on Loop 1.
3.2 Record
Once a loop is armed, pressing the footswitch for that loop will be-
gin recording. The corresponding loop LED will glow red to indicate
recording. You must record to Loop 1 first. You will be able to record
on Loop 2 once there is audio recorded on Loop 1.
Pressing a Loop footswitch after the loop has started recording will
stop recording and immediately begin playback. The loop LED will
glow green to indicate playback.
Pressing the Stop footswitch while a loop is recording will stop record-
ing without immediate playback. You will need to press the appro-
priate loop footswitch again to begin playback.
17