OFNA Racing JL10e User Manual

Page 2

ASSEMBLY OF THE FRONT AND REAR BALL DIFF.

CHECKING BALL DIFF.

ASSEMBLY OF THE FRONT AND REAR BALL DIFF.

Step 2

37450
10x15mm Ball Bearing

37132
2.6x6x1mm Washer

.....x4

37137
9.6x11x0.8mm Ring

Builds two differentials for front and rear

35958

35958
5x8mm Ball Bearing

.....x4

37132

Screw

2.6x25mm

.....x2

Apply
Grease

35958

37120

37110

37145

40060

37132

40060
2.6mm Nylon Nut

.....x2

Stabilize with
hex wrench or
screw driver.

Flat Head Screw Driver

* Turn to check.

phillips screw
driver

37450

Step 1

Step 2

Step 1

37137

37145

37148

38288

Step 1

Step 2

Step 3

37132

Parallel two Flat Head screw drives to the cap joint as show,
and rotate the differential gear to check if it slip.
If the differential gear slips, make a adjustments with a
phillips screw driver.

Use a phillips screw driver to tighten or loosen the ball
differential. Please note that the diff washer may be
damaged if the screw is over tightened or if diff gear slips
easily.

In the condition that the differential gear doesn't
slip, turn one of the cap joint and see if the other
cap joint turns in opposite direction.
Repeat step 2 several times until the gear turn
smoothly and without slip.

Builds two differentials for
front and rear.

(12 Pcs)