OFNA Racing Jammin SCRT Nitro RTR User Manual

Page 30

ASSEMBLY OF THE CLUTCH

ASSEMBLY OF THE ENGINE ONTO CHASSIS

ASSEMBLY OF THE CLUTCH AND ENGINE MOUNT

Step 2

10098

40814

10009

10102

•Fit the flywheel using a pair of the
plIer and cross wrench.

•Place the clutch shoes with the clutch
springs over the 3 pins of the flywheel.
•Using a screw driver or needle nose
pliers and bend the small end of the
clutch spring behind the pilot shaft
10102 than press down.

Step 1

•Only use the 10091 pilot shaft for threaded crank
shaft engine.

10091
Pilot Shaft
(Not Included)

Threaded
Crank Shaft

cre

eme

40814

38430

Step 1

Step 2

10399

34110

3x8mm

3x5mm

5x8x0.3mm

5x8x0.8mm

3mm

38150

3x12mm

.....x2

.....x1

10412
5x8x0.3mm Washer

34110
5x10x4mm
Ball Bearing

94040
3x8mm Washer

10410
3x5mm Cap Screw

.....x2

10410
5x8x0.8mm Washer

94038
3x12mm Cap Screw

.....x1

.....x4

3mm
Nylon Nut

.....x4

•Slide the 3mm nylon
nut into engine mount.

94002
3x8mm
Hex Screw

.....x4

•Use note book paper to set gear backlash
between spur gear and clutch bell gear,
applying pressure while re-tightening the
engine.
•If the space is not correct the spur gear
will be damaged.

Note book Paper.

3x8mm