Chemtronics Arctic Storm ES1056 - Manual

PRODUCT DESCRIPTION
Arctic Storm™ Freeze Spray is specifically designed
for cooling large areas of a printed circuit board at
once to locate thermally intermittent sections.
Utilizing an ultra-low global warming potential
coolant, this product offers the best cooling possible
with the lowest global warming impact available.
Arctic Storm™ Freeze Spray is nonflammable,
residue-free and provides very fast cooling action.
 Cools surfaces to below -49°F / -45 °C
 Wide spray for whole board cooling
 Ultra-low global warming impact of 6
 Nonflammable
 High heat transfer
 Noncorrosive
 Ultra-pure, filtered to <0.2 microns
 Leaves no residue
 Nonabrasive on most surfaces
 CFC, HCFC and HFC free
 VOC free
TYPICAL APPLICATIONS
Arctic Storm™ Freeze Spray can be used to:
 Cool Equipment for Testing
 Dissipate Heat While Soldering or
Desoldering
 Isolate Thermal Intermittent Components
 Test Circuit Traces for Continuity
 Test Printed Circuit Boards for Stress
Fractures
 Track Intermittent Failures and Shorts
COMPATIBILITY
Arctic Storm™ Freeze Spray is generally compatible
with most materials used in printed circuit board
fabrication, including sensitive plastics and
compounds. With any circuit refrigerant,
compatibility must be determined on a non-critical
area prior to use.
TYPICAL PRODUCT DATA AND PHYSICAL
PROPERTIES
Boiling Point -2 °F / -19 °C
Cools To: -49 °F / -45 °C
Vapor Density (air=1)
@ 70
°F
4.0
Solubility in Water
@ 70
°F /1 atm
>0.10% by weight
Specific Gravity
(water = 1 @70
°F)
1.17
Evaporation Rate >1
(butyl acetate=1)
Appearance Clear, Colorless
Liquified Gas
Odor Slight Ethereal
Internal Pressure 47 psia @ 70 °F
Flash Point (TCC) None
Shelflife 5 years
RoHS/WEEE
Status
TDS # 1056
CHEMTRONICS
Technical Data Sheet
Arctic Storm™ Freeze Spray