Chemtronics Arctic Blast Antistat ES1055 - Manual

PRODUCT DESCRIPTION
Arctic Blast™ Antistat Freeze Spray is engineered for
locating thermal intermittent electrical components or
cooling printed circuit boards with minimal static
generation. Utilizing an ultra-low global warming
potential coolant, this product offers the best cooling
possible with the lowest global warming impact
available. Arctic Blast™ Antistat is nonflammable,
residue-free and provides fast cooling action.
 Cools surfaces to below -49°F / -45 °C
 Minimal static generation
 Ultra-low global warming impact of 6
 Nonflammable
 High heat transfer
 Pinpoint spray for individual component isolation
 Noncorrosive
 Ultra-pure, filtered to <0.2 microns
 Leaves no residue
 Nonabrasive on most surfaces
 CFC, HCFC and HFC free
TYPICAL APPLICATIONS
Arctic Blast™ Antistat Freeze Spray can be used to:
• Cool Equipment for Testing
• Dissipate Heat While Soldering or
Desoldering
• Isolate Thermal Intermittent Components
• Test Circuit Traces for Continuity
• Test Printed Circuit Boards for Stress
Fractures
• Track Static Sensitive Components
COMPATIBILITY
Arctic Blast™ Antistat is generally compatible with
most materials used in printed circuit board
fabrication, including sensitive plastics and
compounds. With any circuit refrigerant,
compatibility must be determined on a non-critical
area prior to use.
TYPICAL PRODUCT DATA AND PHYSICAL
PROPERTIES
Boiling Point -2 °F / -19 °C
Cools To: -49 °F / -45 °C
Vapor Density (air=1)
@ 70
°F
4.0
Solubility in Water
@ 70
°F /1 atm
>1.0% by weight
Specific Gravity
(water = 1 @70
°F)
1.17
Evaporation Rate >1
(butyl acetate=1)
Appearance Clear, Colorless
Liquified Gas
Odor Slight Ethereal
Internal Pressure 47 psia @ 70 °F
Flash Point (TCC) None
Shelflife 5 years
RoHS/WEEE
Status
TDS # 1055
CHEMTRONICS
Technical Data Sheet
Arctic Blast™ Antistat Freeze Spray