Chemtronics Arctic Blast ES1054 User Manual
Technical data sheet, Arctic blast™ freeze spray, Chemtronics

PRODUCT DESCRIPTION
Arctic Blast™ Freeze Spray is specifically designed
for locating thermal intermittent electrical
components and cooling printed circuit boards.
Utilizing an ultra-low global warming potential
coolant, this product offers the best cooling possible
with the lowest global warming impact. Arctic
Blast™ Freeze Spray is nonflammable, residue-free
and provides fast cooling action.
Cools surfaces to below -49°F / -45 °C
Ultra-low global warming impact of 6
Nonflammable
High heat transfer
Pinpoint spray for individual component isolation
Noncorrosive
Ultra-pure, filtered to <0.2 microns
Leaves no residue
Nonabrasive on most surfaces
CFC, HCFC and HFC free
VOC free
TYPICAL APPLICATIONS
Arctic Blast™ Freeze Spray can be used to:
Cool Equipment for Testing
Dissipate Heat While Soldering or
Desoldering
Isolate Thermal Intermittent Components
Test Circuit Traces for Continuity
Test Printed Circuit Boards for Stress
Fractures
Track Intermittent Failures and Shorts
COMPATIBILITY
Arctic Blast™ Freeze Spray is generally compatible
with most materials used in printed circuit board
fabrication, including sensitive plastics and
compounds. With any circuit refrigerant,
compatibility must be determined on a non-critical
area prior to use.
TYPICAL PRODUCT DATA AND PHYSICAL
PROPERTIES
Boiling Point -2 °F / -19 °C
Cools To:
-49 °F / -45 °C
Vapor Density (air=1)
@ 70
°F
4.0
Solubility in Water
@ 70
°F /1 atm
>0.10% by weight
Specific Gravity
(water = 1 @70
°F)
1.17
Evaporation Rate >1
(butyl acetate=1)
Appearance Clear, Colorless
Liquified Gas
Odor
Slight Ethereal
Internal Pressure
47 psia @ 70 °F
Flash Point (TCC)
None
Shelflife 5 years
RoHS/WEEE
Status
TDS # 1054
CHEMTRONICS
Technical Data Sheet
Arctic Blast™ Freeze Spray