Chemtronics Pow-R-Wash CZ ES7300 - Manual (Page 5)

Pow-R-Wash™ CZ
8. Exposure controls/personal protection
Safety eyewear complying with an approved standard should be used when a risk
assessment indicates this is necessary to avoid exposure to liquid splashes, mists or
dusts. If contact is possible, the following protection should be worn, unless the
assessment indicates a higher degree of protection: chemical splash goggles.
Personal protective equipment for the body should be selected based on the task being
performed and the risks involved and should be approved by a specialist before
handling this product. Eyes
Skin
:
:
Chemical-resistant, impervious gloves complying with an approved standard should be
worn at all times when handling chemical products if a risk assessment indicates this is
necessary. Considering the parameters specified by the glove manufacturer, check
during use that the gloves are still retaining their protective properties. It should be
noted that the time to breakthrough for any glove material may be different for different
glove manufacturers. In the case of mixtures, consisting of several substances, the
protection time of the gloves cannot be accurately estimated. Hands :
Environmental exposure
controls : Emissions from ventilation or work process equipment should be checked to ensure
they comply with the requirements of environmental protection legislation. In some
cases, fume scrubbers, filters or engineering modifications to the process equipment
will be necessary to reduce emissions to acceptable levels.
32°C (89.6°F)
Liquid. [Aerosol.]
100% (v/v)
1.5
>1 [Air = 1]
29.3 kPa (220 mm Hg) [room temperature]
Not dispersible in the following materials: cold water.
Ethereal.
Clear. Colorless.
Boiling/condensation point
>1 (butyl acetate = 1)
9. Physical and chemical properties
Physical state
Relative density
Vapor pressure
Vapor density
Volatility
Evaporation rate
Dispersibility properties
Odor
Color
:
:
:
:
:
:
:
:
:
:
Flash point : [Product does not sustain combustion.]
Type of aerosol : Spray
Aerosol product
The product is stable.
Reactive or incompatible with the following materials: zinc Magnesium. Aluminum.
alkalis oxidizing materials acids Alkaline.
Under normal conditions of storage and use, hazardous decomposition products should
not be produced.
Avoid all possible sources of ignition (spark or flame). Do not pressurize, cut, weld,
braze, solder, drill, grind or expose containers to heat or sources of ignition. Do not
spray on a naked flame or any incandescent material. open flames, sparks and static
discharge
10. Stability and reactivity
Chemical stability
Conditions to avoid
Incompatible materials
Hazardous decomposition
products
:
:
:
:
Possibility of hazardous
reactions : Under normal conditions of storage and use, hazardous reactions will not occur.
5/10 3103 6/12/2013.