Chemtronics Flux-Off Water Soluble ES1530 User Manual
Technical data sheet, Flux-off, Water soluble flux remover

PRODUCT DESCRIPTION
The
Flux-Off
Water Soluble
CARB
Compliant formulation is a proprietary blend
of powerful cleaning solvents designed to
replace TMS based solvents. This defluxing
agent removes R, RMA, RA, and synthetic
flux residues, as well as ionic and non-ionic
soils.
Removes R, RMA, RA, and synthetic flux
residues
Penetrates hard to reach areas
Evaporates quickly
Leaves no residues
Removes light oil and grease residues
Removes ionic and non-ionic residues
Excellent material compatibility
Non-corrosive formulation
Contains no CFCs or HCFCs
TYPICAL APPLICATIONS
Flux-Off
Water Soluble removes flux
residues and cleans:
Chip Carriers
Heat Sinks
Plugs
Printed Circuit Boards
Relays
Sockets
Surface Mount Device Pads
Switches
TYPICAL PRODUCT DATA AND
PHYSICAL PROPERTIES
Boiling Point
180
°F Initial
Solubility in Water
Soluble
Specific Gravity
Aerosol 0.79
Liquid 0.84
Evaporation Rate (butyl acetate=1) >1
Surface Tension
(dynes/cm @21.6
°C)
21.1
Flash Point (TCC)
70
°F
Kauri-Butanol (KB) Number 80
VOC* Content: Aerosol Liquid
CARB 75% 75 %
SCAQMD 663 g/L 626 g/L
Federal 75% 75
%
RoHS Compliant
Shelflife Aerosols 5 years
Liquids 2 years after opening
*Volatile Organic Compound (VOC) information is calculated on a
weight basis using the VOC definition of California Air Resources
Board (CARB) Consumer Product Regulations, South Coast Air
Quality Management District (SCAQMD) Rule 102 and the Federal
definition published in 40 CFR 51.100(s).
COMPATIBILITY
Flux-Off
Water Soluble is generally
compatible with most materials used in the
electronics industry. As with any cleaning
agent, solvent/component compatibility must
be determined on a non-critical area prior to
use.
CHEMTRONICS
Technical Data Sheet
Flux-Off
Water Soluble Flux Remover
TDS #1530