Chemtronics Electro-Wash PR ES1603 - Manual

PRODUCT DESCRIPTION
Electro-Wash

PR is a fast drying, one step
degreasing agent and cleaner that is safe for
most plastics. Engineered with very low
surface tension, this high pressure aerosol
formulation
flushes areas clean and
evaporates instantly leaving no residue.
 Removes oxides, dust, dirt, and grease
 Penetrates hard to reach areas
 Evaporates quickly
 Leaves no residues
 Has low odor
 Noncorrosive
 Contains no CFCs, HCFCs or
1,1,1 Trichloroethane
 Contains no Chlorinated Solvents
TYPICAL APPLICATIONS
Electro-Wash

PR removes grease, oils and
other soils from:
 Printed Circuit Boards
 Relays and Contacts
 Fuse Boxes
 TVs / VCRs
 Solder Paste Screens
 Timers
 Wire Harnesses
 Plastic Housings
TYPICAL PRODUCT DATA AND
PHYSICAL PROPERTIES
Boiling Point 141

F Initial
Dielectric Strength 24 Kv
Flash Point (TCC) -20.0

F
Appearance Clear Colorless Liquid
Odor Mild
Solubility in Water Negligible
Specific Gravity
(water =
1@68

F )
0.67
Evaporation Rate < 1
(butyl acetate=1)
Surface Tension
(dynes/cm @21.6

C)
18.3
Kauri-Butanol
(KB) Number 50
VOC* Content: Aerosol
CARB 75%
SCAQMD 548 g/L
Federal 75%
Shelflife 5 years
COMPATIBILITY
Electro-Wash

PR is generally compatible with most
materials used in printed circuit board fabrication,
except acrylics, ABS resins, polycarbonates and
polystyrenes. As with any cleaning agent
solvent/component compatibility must be determined
on a non-critical area prior to use.
TDS # 1603
CHEMTRONICS
Technical Data Sheet
Electro-Wash

PR