Chemtronics Electro-Wash NXO ES107 - Manual (Page 4)

Electro-Wash® NXO
6. Accidental release measures
Stop leak if without risk. Move containers from spill area. Approach release from
upwind. Prevent entry into sewers, water courses, basements or confined areas. Wash
spillages into an effluent treatment plant or proceed as follows. Contain and collect
spillage with non-combustible, absorbent material e.g. sand, earth, vermiculite or
diatomaceous earth and place in container for disposal according to local regulations
(see Section 13). Dispose of via a licensed waste disposal contractor. Contaminated
absorbent material may pose the same hazard as the spilled product. Note: see
Section 1 for emergency contact information and Section 13 for waste disposal. Large spill :
Stop leak if without risk. Move containers from spill area. Dilute with water and mop up
if water-soluble. Alternatively, or if water-insoluble, absorb with an inert dry material and
place in an appropriate waste disposal container. Dispose of via a licensed waste
disposal contractor. Small spill :
Methods for cleaning up
Store in accordance with local regulations. Store in original container protected from
direct sunlight in a dry, cool and well-ventilated area, away from incompatible materials
(see Section 10) and food and drink. Keep container tightly closed and sealed until
ready for use. Containers that have been opened must be carefully resealed and kept
upright to prevent leakage. Do not store in unlabeled containers. Use appropriate
containment to avoid environmental contamination.
Put on appropriate personal protective equipment (see Section 8). Eating, drinking and
smoking should be prohibited in areas where this material is handled, stored and
processed. Workers should wash hands and face before eating, drinking and smoking.
Remove contaminated clothing and protective equipment before entering eating areas.
Avoid exposure - obtain special instructions before use. Do not get in eyes or on skin or
clothing. Do not ingest. Avoid breathing vapor or mist. If during normal use the
material presents a respiratory hazard, use only with adequate ventilation or wear
appropriate respirator. Keep in the original container or an approved alternative made
from a compatible material, kept tightly closed when not in use. Empty containers retain
product residue and can be hazardous. Do not reuse container.
7. Handling and storage
Handling
Storage
:
:
trans-dichloroethylene ACGIH TLV (United States, 3/2012).
TWA: 200 ppm 8 hours.
TWA: 793 mg/m³ 8 hours.
Butane, 1,1,1,2,2,3,3,4,4-nonafluoro-4-methoxy- AIHA WEEL (United States, 10/2011).
TWA: 750 ppm 8 hours.
Propane, 2-(difluoromethoxymethyl)-1,1,1,2,3,3,
3-heptafluoro- AIHA WEEL (United States, 10/2011).
TWA: 750 ppm 8 hours.
ethanol ACGIH TLV (United States, 3/2012).
STEL: 1000 ppm 15 minutes.
NIOSH REL (United States, 1/2013).
TWA: 1900 mg/m³ 10 hours.
TWA: 1000 ppm 10 hours.
OSHA PEL (United States, 6/2010).
TWA: 1900 mg/m³ 8 hours.
TWA: 1000 ppm 8 hours.
OSHA PEL 1989 (United States, 3/1989).
TWA: 1900 mg/m³ 8 hours.
TWA: 1000 ppm 8 hours.
8. Exposure controls/personal protection
United States
Canada
Ingredient Exposure limits
4/14 4014L 7/23/2013.