Chemtronics CircuitWorks® Rosin Flux Remover Pen CW9200 User Manual

Page 2

COMPATIBILITY
CircuitWorks



Flux Remover Pens are

generally compatible with most materials used
in the electronics industry. As with any
cleaning agent, material compatibility should
be determined on a non-critical area prior to
use.

USAGE INSTRUCTIONS
For industrial use only.
Read MSDS carefully prior to use.
Hold pen vertically and briefly depress tip to
start liquid flow. Rub pen tip on surface to be
cleaned. Wipe tip on a ControlWipe

 dry

wipe to remove buildup

CAUTION: Products are Flammable - Do not
use near sources of ignition and energized
equipment.

AVAILABILITY

CW9100 9 gm (0.32 oz) No Clean Flux Remover Pen
CW9200 8 gm (0.28 oz) Rosin Flux Remover Pen

TECHNICAL & APPLICATION
ASSISTANCE

Chemtronics provides a technical hotline to
answer your technical and application related
questions. The toll free number is: 1-800-TECH-
401.

NOTE:

This information is believed to be accurate. It is

intended for professional end users having the skills to
evaluate and use the data properly.
CHEMTRONICS does not guarantee the accuracy of the
data and assumes no liability in connection with damages
incurred while using it.

Chemtronics

, and CircuitWorks are registered trademarks of

 is a trademark

CHEMTRONICS
8125 COBB CENTER DRIVE
KENNESAW, GA 30152
1-770-424-4888

REV. D (08/13)

DISTRIBUTED BY:

This manual is related to the following products:

CircuitWorks® No Clean Flux Remover Pen CW9100