Chemtronics CircuitWorks® Lead-Free Flux Dispensing Pen CW8400 User Manual
Page 2
USAGE INSTRUCTIONS
For industrial use only.
Read MSDS carefully prior to use.
Hold pen vertically and briefly depress tip to
start liquid flow. Rub pen tip on surface to be
fluxed. After soldering, wipe area around
soldered joint using a ControlWipe
to
remove unreacted flux.
No Clean flux residues are designed to be left
on the board, however, they can be easily
removed with Chemtronics Flux-Off
Lead-
Free Flux Remover or CircuitWorks
Lead-
Free Flux Remover Pen (CW9400).
AVAILABILITY
CW8400 9 gm (0.32 oz)
TECHNICAL & APPLICATION
ASSISTANCE
Chemtronics provides a technical hotline to answer
your technical and application related questions. The
toll free number is: 1-800-TECH-401.
NOTE: This information is believed to be accurate.
It is intended for professional end users having the
skills to evaluate and use the data properly.
CHEMTRONICS does not guarantee the accuracy of
the data and assumes no liability in connection with
damages incurred while using it.
CHEMTRONICS
8125 COBB CENTER DRIVE
KENNESAW, GA 30152
1-770-424-4888
REV. C (08/13)
Chemtronics
, Flux-Off®, and CircuitWorks are registered
trademarks of Chemtronics. All rights reserved. ControlWipe
is a trademark of Chemtronics. All rights reserved.
DISTRIBUTED BY: