Chemtronics CircuitWorks® Lead-Free Flux CW3220 User Manual
Page 2
COMPATIBILITY
CircuitWorks
Lead-Free Flux is
generally compatible with most materials
used in the electronics industry. As with
any fluxing agent, material compatibility
should be determined on a non-critical
area prior to use.
Performance
Test
Results
Silver Chromate Method
IPC-TM 650 Test Method 2.3.33
PASS
Copper Corrosion Test
IPC-TM 650 Test Method 2.6.15
PASS
Copper Mirror Test
IPC-TM 650 Test Method 2.3.32
No Evidence of
Corrosion
J-STD-004 Surface Insulation
Resistance Testing
IPC-TM 650 Test Method 2.6.3.3
PASS
USAGE INSTRUCTIONS
For industrial use only.
Read MSDS carefully prior to use.
Can be sprayed or hand applied to the surface
being soldered. After soldering, wipe area
around solder joint using a ControlWipe
to
remove unreacted flux.
No Clean flux residues are designed to be left
on the board, however, they can be easily
removed with Chemtronics Flux-Off
Lead-
Free Flux Remover (ES897B or ES1697) or
CircuitWorks
Lead-Free Flux Remover Pen
(CW9400).
AVAILABILITY
CW3220 32 ounces (1 quart)
Also available:
CircuitWorks
Lead-Free Flux Dispensing Pen
CW8400
9 gm (0.32 oz)
TECHNICAL & APPLICATION
ASSISTANCE
Chemtronics provides a technical hotline to
answer your technical and application related
questions. The toll free number is 1-800-
TECH-401, or e-mail us at
ITW Chemtronics is also accessible on the
web. Visit us at www.chemtronics.com.
NOTE: This information is believed to be
accurate. It is intended for professional end users
having the skills to evaluate and use the data
properly.
CHEMTRONICS does not guarantee the accuracy
of the data and assumes no liability in connection
with damages incurred while using it.
CHEMTRONICS
8125 COBB CENTER DRIVE
KENNESAW, GA 30152
1-770-424-4888
REV. B (08/13)
Chemtronics
, Flux-Off, and CircuitWorks are
registered trademarks of Chemtronics. All rights reserved.
ControlWipe
is a trademark of Chemtronics. All rights
reserved.
DISTRIBUTED BY: