Chemtronics CircuitWorks® Conformal Coating Remover Pen CW3500 - Manual (Page 2)

COMPATIBILITY
The CircuitWorks

Conformal Coating
Remover Pen material is compatible with
most materials used in printed circuit board
fabrication. As with any solvent,
compatibility with substrate should be
determined on a non-critical area prior to
use.
USAGE INSTRUCTIONS
Read MSDS carefully prior to use.
1. Hold pen vertically and briefly depress
tip to start liquid flow.
2. Allow liquid to sit on the conformal
coating for 15 - 20 seconds, then rub area
with pen tip until coating is removed.
Wipe area clean with a Controlwipes
TM
Wipe.
3. Wipe tip on a Controlwipes
TM
Wipe to
remove buildup.
4. Change tips if necessary.
AVAILABILITY
CW3500 9.0g (0.32 oz.) Pen
TECHNICAL & APPLICATION
ASSISTANCE
Chemtronics provides a technical hotline to answer
your technical and application related questions.
The toll free number is: 1-800-TECH-401.
NOTE:
This information is believed to be accurate. It is
intended for professional end users having the skills
to evaluate and use the data properly.
CHEMTRONICS does not guarantee the accuracy
of the data and assumes no liability in connection
with damages incurred while using it.
CHEMTRONICS
8125 COBB CENTER DRIVE
KENNESAW, GA 30152
1-770-424-4888
REV. F (08/13)
DISTRIBUTED BY: