Chemtronics CircuitWorks® 60 Minute Conductive Epoxy CW2460 - Manual (Page 9)

CIRCUITWORKS® 60 MINUTE CONDUCTIVE EPOXY - Part B (Hardener)
15. Regulatory information
Australia inventory (AICS): All components are listed or exempted.
China inventory (IECSC): All components are listed or exempted.
Japan inventory: Not determined.
Korea inventory: All components are listed or exempted.
Malaysia Inventory (EHS Register): Not determined.
New Zealand Inventory of Chemicals (NZIoC): All components are listed or exempted.
Philippines inventory (PICCS): All components are listed or exempted.
Taiwan inventory (CSNN): Not determined. International lists :
Chemical Weapons
Convention List Schedule
I Chemicals : Not listed
Chemical Weapons
Convention List Schedule
II Chemicals : Not listed
Chemical Weapons
Convention List Schedule
III Chemicals : Not listed
Not available.
Not available.
16. Other information
References
Other special
considerations
Hazardous Material
Information System (U.S.A.)
3
0
0
Health
Flammability
Physical hazards
CAUSES EYE AND SKIN BURNS. HARMFUL IF ABSORBED THROUGH SKIN.
CAUSES RESPIRATORY TRACT IRRITATION. MAY CAUSE ALLERGIC SKIN
REACTION. Label requirements :
Notice to reader
To the best of our knowledge, the information contained herein is accurate. However, neither the above-named
supplier, nor any of its subsidiaries, assumes any liability whatsoever for the accuracy or completeness of the
information contained herein.
Final determination of suitability of any material is the sole responsibility of the user. All materials may present
unknown hazards and should be used with caution. Although certain hazards are described herein, we cannot
guarantee that these are the only hazards that exist.
Date of printing
Date of issue
Date of previous issue
Version 10/21/2013. :
:
:
:
:
:
:
Caution: HMIS® ratings are based on a 0-4 rating scale, with 0 representing minimal hazards or risks, and 4
representing significant hazards or risks Although HMIS® ratings are not required on MSDSs under 29 CFR 1910.
1200, the preparer may choose to provide them. HMIS® ratings are to be used with a fully implemented HMIS®
program. HMIS® is a registered mark of the National Paint & Coatings Association (NPCA). HMIS® materials may
be purchased exclusively from J. J. Keller (800) 327-6868.
The customer is responsible for determining the PPE code for this material.
Indicates information that has changed from previously issued version.
10/21/2013.
No previous validation.
1
Prepared by : Not available.
9/9 2460B 10/21/2013.