Chemtronics Chemask® LF - Lead-Free CLF8 - Manual (Page 5)

Chemask® Lead-Free
8. Exposure controls/personal protection
Safety eyewear complying with an approved standard should be used when a risk
assessment indicates this is necessary to avoid exposure to liquid splashes, mists or
dusts. If contact is possible, the following protection should be worn, unless the
assessment indicates a higher degree of protection: chemical splash goggles.
Personal protective equipment for the body should be selected based on the task being
performed and the risks involved and should be approved by a specialist before
handling this product. Eyes
Skin
:
:
Chemical-resistant, impervious gloves complying with an approved standard should be
worn at all times when handling chemical products if a risk assessment indicates this is
necessary. Considering the parameters specified by the glove manufacturer, check
during use that the gloves are still retaining their protective properties. It should be
noted that the time to breakthrough for any glove material may be different for different
glove manufacturers. In the case of mixtures, consisting of several substances, the
protection time of the gloves cannot be accurately estimated. Hands :
Environmental exposure
controls : Emissions from ventilation or work process equipment should be checked to ensure
they comply with the requirements of environmental protection legislation. In some
cases, fume scrubbers, filters or engineering modifications to the process equipment
will be necessary to reduce emissions to acceptable levels.
38°C (100.4°F)
paste
5% (w/w)
<1 [Air = 1]
101.3 kPa (760 mm Hg) [room temperature]
Ammoniacal. [Slight]
Pale pink color.
Boiling/condensation point
>1 (butyl acetate = 1)
190,000 cps
9. Physical and chemical properties
Physical state
Vapor pressure
Vapor density
Volatility
Evaporation rate
Viscosity
Odor
Color
:
:
:
:
:
:
:
:
:
Flash point : [Product does not sustain combustion.]
The product is stable.
No specific data.
Under normal conditions of storage and use, hazardous decomposition products should
not be produced.
No specific data.
10. Stability and reactivity
Chemical stability
Conditions to avoid
Incompatible materials
Hazardous decomposition
products
:
:
:
:
Possibility of hazardous
reactions : Under normal conditions of storage and use, hazardous reactions will not occur.
11. Toxicological information
Acute toxicity
methanol LC50 Inhalation Gas. Rat 145000 ppm 1 hours
LC50 Inhalation Gas. Rat 64000 ppm 4 hours
LD50 Dermal Rabbit 15800 mg/kg -
LD50 Oral Rat 5600 mg/kg -
Product/ingredient name Result Species Dose Exposure
Conclusion/Summary : Not available.
Chronic toxicity
5/10 0714 5/1/2014.