Chemtronics Chemask® Peelable CM8 - Manual (Page 5)

Chemask®
8. Exposure controls/personal protection
Not available.
Safety eyewear complying with an approved standard should be used when a risk
assessment indicates this is necessary to avoid exposure to liquid splashes, mists or
dusts. If contact is possible, the following protection should be worn, unless the
assessment indicates a higher degree of protection: chemical splash goggles.
Personal protective equipment for the body should be selected based on the task being
performed and the risks involved and should be approved by a specialist before
handling this product. Eyes
Skin
:
:
Chemical-resistant, impervious gloves complying with an approved standard should be
worn at all times when handling chemical products if a risk assessment indicates this is
necessary. Considering the parameters specified by the glove manufacturer, check
during use that the gloves are still retaining their protective properties. It should be
noted that the time to breakthrough for any glove material may be different for different
glove manufacturers. In the case of mixtures, consisting of several substances, the
protection time of the gloves cannot be accurately estimated. Hands :
Other protection : Not available.
Environmental exposure
controls : Emissions from ventilation or work process equipment should be checked to ensure
they comply with the requirements of environmental protection legislation. In some
cases, fume scrubbers, filters or engineering modifications to the process equipment
will be necessary to reduce emissions to acceptable levels.
Personal protective
equipment (Pictograms) :
38°C (100.4°F)
Liquid.
5% (w/w)
Not available.
Not available.
Not available.
<1 [Air = 1]
101.3 kPa (760 mm Hg) [room temperature]
Not available.
Not available.
Not available.
Not available.
Not available.
Not applicable.
Ammoniacal. [Slight]
Not available.
Pale pink color.
Boiling/condensation point
Melting/freezing point
>1 (butyl acetate = 1)
Dynamic (room temperature): 15000 mPa·s (15000 cP)
9. Physical and chemical properties
Physical state
Molecular weight
pH
Critical temperature
Relative density
Vapor pressure
Vapor density
Volatility
Odor threshold
Evaporation rate
Viscosity
Ionicity (in water)
Dispersibility properties
Solubility
Odor
Taste
Color
Not applicable. Molecular formula
:
:
:
:
:
:
:
:
:
:
:
:
:
:
:
:
:
:
:
:
Flash point : [Product does not sustain combustion.]
Not available. : Auto-ignition temperature
Flammable limits
: Not available.
Burning time Not applicable. :
Burning rate : Not applicable.
SADT : Not available.
5/10 0704 6/12/2013.