NextoDI ND2730 - Manual (Page 8)

09
CHARGING THE RECHARGEABLE BATTERY ND2730 INTERFACE
10
8. Charging the Rechargeable Battery
1. Internal battery
The battery can be charged using the AC power adapter unit delivered
with this product.
A. Turn off the ND2730.
B. Connect the charger’s wall plug to the ND2730’s "DC IN" slot
C. Plug the AC power adapter unit into a wall socket
D. The LED above the control key shows red when charging
E. When the battery is charged, the red LED turns off
F. If there is an error when charging, the LED blinks. If this happens,
unplug the AC adapter unit and plug it in again.
Users can charge the ND2730 via the car charger, the USB/
FireWire 800 (IEEE 1394b) cable, or the AA battery holder (optional).
With a completely empty rechargeable battery, the charging
procedure lasts approximately 4 hours using the AC power adapter,
the car charger cable, the USB cable, or the FireWire 800 (IEEE 1394b)
cable.
Reference
● You must turn off the ND2730 in order to charge the unit.
● The ND2730 can be charged via USB without using the AC power adapter
included in the box. A high powered USB connection is needed, i.e. a USB
connection with its own power supply, such as the USB port of a computer or
a USB hub with a power unit.
● If the ND2730 is operated with a notebook, you must always use the AC power
adapter unit to charge the ND2730. Notebooks may not deliver the necessary
amount of current via USB.
● The ND2730 will operate for about two hours with a fully charged internal
battery.
● When connected to a computer using FireWire 800 (IEEE 1394b) or USB,
the ND2730 draws power from the computer, not the internal battery.
● If the ND2730’s battery is completely discharged, the performance of the
battery may be degraded. It is recommended that the ND2730‘s battery be
recharged before the battery gauge reaches the empty level.
1. Turning the ND2730 On/Off
9. ND2730 Interface
Reference
● The ND2730 can be reset via the recessed RESET key (see chapter 6).
This will also turn the power off.
Press the control key for more than 2 seconds in order
to turn the ND2730 on. The power up logo and firmware
version is shown on the LCD.
When you see the logo on the LCD screen, release
the button. Otherwise, the ND2730 will automatically
power down.
After checking the system, the ND2730 goes into
[XCopy ready] mode. You can copy a memory card
in this mode.
The ND2730 turns off automatically after about 30
seconds if you do not use it.
When the Off control option appears on the LCD,
the ND2730 can be powered off by pressing down on
the control key for more than 2 seconds.
PHOTO STORAGE
Ver 1.00
Power Off !!
XCopy Ready
245.0 G
Menu Off