Hit Products Logic 3 User Manual
Page 2
TABLE OF CONTENTS
1. Installing the Logic 2 and Logic 3, Valve Wiring
2. Valve Wiring
3. Selecting Proper Wire Size
4. Wire Connections
5. Testing Controller Surge Protection Board
6. Controller Lightning Protection
7. Features and Programming the Logic 2 and the Logic 3
8. Pre Wet, Fertigation and Setting Pause
9. Start Times, Total Run Times and Calendar
10. Definitions and Looping Program 6
11. Program/Master Valve ON/OFF, Test Cycle
12. Semi/Manual/Program Clear, Rain Delay, Run
13. Programming of Logic Receivers / Diamond Settings
14. Receiver Programming Instructions
15. Receiver Number Identification Tags, “Do’s & Don’ts”
16. Rain OFF Wiring Instructions
17. Rain OFF Diagram
18. Wire Chart
19. Wire Chart
20. Common Field Wiring Example
21. Field Wire Example -Pump Start Relay
22. Field Lightning and Surge Protection Wiring Diagram
Installation and field wiring instructions.
Read booklet completely before beginning installation.
NOTICE: Before installation, receivers must all be
programmed. See page 14 for receiver programming
instructions