Hit Products Logic 3 - Manual (Page 11)

Position 4
Start Time
To set start times, use set 1 to choose the desired program, use set 2 to choose
the start number, (always use start 1 for the first start time after midnight and so
on through start 8 (Logic II) start 16 (Logic III) use set 3 to set the hour of the
start time, use set 4 to set the minutes of the start time.
Note: The start time is part of the first leg of a preprogrammed function
called “Diamond Settings” Refer to Diamond settings at the end of this
programming guide for full details.
Position 5
Total Run Time
To review the total run time in a specific program, use set 1 to choose the
program number. The total run time of that specific program is shown in the lower
right hand position of the display. You can review the water budget setting along
with the total run time in this position. If the water budget is changed from the
default of 100%, the total run times will change in this position, but in position 2,
the valve run times will stay as inputted. The actual running of the valve is
determined by the input in position 2 multiplied by the water budget setting in
position 8.
To review the numbered day of the calendar the controller is currently on, use set
1 to choose the program desired. The day of the calendar will be displayed
directly right of the word “DAY” in the upper display. You can change the day of
the calendar by using set 3 buttons. This will or can bring all days of all programs
to the same day for calendar purposes.
Note: By adjusting the budget up or down (0% to 250%) it will change the total
run time. See position 8 for further discussion. The budget is the second leg of
the Diamond Setting.
Position 6
Calendar
The calendar is the third leg of the Diamond Setting. After programming the run
times and the start times, the calendar will automatically establish the minimum
calendar period. You can manually change the calendar to any desired period,
longer than the minimum “Auto -calendar” period, but not shorter. By pressing set
1 to select the program, press set 2 to change the number of days desired in the
calendar, (if the total run time exceeds one day, the calendar can not be set
backwards. Press set 3 to review the days of the calendar. By pressing set 3
repetitively, the display above set 4 will show one of the following events: Strt
(start), run or off for each day of the calendar. Note: The calendar automatically
resets all programs to Day 1, today, for all programs when “Master Clear” is
activated. The calendar automatically resets to Day 1, today, whenever a
“Program Clear” function is activated for that specific program. The calendar
automatically resets to today, Day 1, when any value in “Calendar” (Position 6) is
changed. The calendar can be manually changed to any day being today in
Position 5, “Total Run Time”. Day value has to be equal to or less than
“calendar” number of days.
9