Clickfree Transformer SE - Manual (Page 74)

Clickfree Transformer SE User Guide Backing up my content (iPod)
Backing up my content (iPod)
H OW DO I START USING MY C LICKFREE T RANSFORMER SE?
♦ To start using your Clickfree Transformer SE:
1. Make sure that your computer is switched on and has finished starting up.
2. Log in, if that is what you normally do.
3. Connect the Clickfree Transformer SE to your computer by plugging it in to a USB port
on your computer.
A USB port usually looks like this: and frequently has a symbol beside
it. USB ports are usually found at the back and front of a desktop computer, often in
pairs. On a laptop computer they may be at the back, front or side.
4. Wait for the Clickfree window to appear. You may have to wait up to a full minute for
your computer to recognize the Clickfree Transformer SE.
5. Connect your iPod to the Clickfree Transformer SE using your iPod’s USB cable.
6. You may have to wait up to a full minute again for your computer to start to run the
ClickFree program – please be patient!
The first time you attach Clickfree to your computer, some messages appear on the
screen telling you that your computer has found new hardware. The messages may
mention ClickFree, Disk drive, and/or CD-ROM drive. You don’t need to do anything
about these messages. Most likely you will not see them when you attach
Clickfree the
next time.
Copyright © 2009 Storage Appliance Corporation. 74