Wine Guardian Ducted Wine Cellar Cooling System (D0200) - Manual - Manual (Page 36)

36
Standard Controller Functions
How to:
Turn system on/off 
Press the “On/Off” button once. Note:
There is a five (5) minute time delay before
the system turns on or turns off.
Change temperature  Press the “Up” arrow once. The display will
show the existing temperature setpoint.

Press the “up or down” arrow buttons to
adjust the temperature to the desired
setpoint.
Change humidity 
Press the “Up” arrow once. This display
will show the existing temperature setpoint.
 Press the “Mode” button once to display the
“Humidity” setpoint.
 Press the “Up” or “Down” arrows to adjust
the humidity to the desired set point. Note –
a Wine Guardian humidifier must be
installed and Setting 6 set to “1” or “2”
before the controller will let you change
percent humidity.
.
Change mode --
Cooling/Heating/Auto  Press the “Mode” button once to display the
“Set” function at the bottom of screen. The
existing mode will display next to the word
“Set” at the bottom of the screen.

Press the mode button again to scroll
through settings for “Cool” (cooling only),
“Heat” (heating only) or “Heat Cool”
(Auto).
Humidity
Temperature
Alarm Indication
Area
Mode Area
Up Button
Down Button
Mode button (right side)
On/Off (left side)