Welch Allyn Service Tool, Installation and Configuration - Installation Guide - Manual (Page 19)

Welch Allyn Service Tool 16 Chapter 3 Operation
Configuring the service tool
Disable the simple user interface
You can configure the service tool to bypass the simple user
interface when starting. If this interface is disabled, users must
activate licenses from the Administration menu.
To disable the simple user interface, do one of these:
• On the simple user interface, select the Do not show this
screen again check box.
• On the service tool’s main screen, select Administration >
Settings, and clear the Simple user interface check box.
Enable clinician access without logon
You can configure the service tool to allow Clinician functionality
without logging on. (Biomed and Admin functionality always requires
a log on.)
1. Log on as ADMIN.
2. Go to the service tool’s main screen.
3. Select Administration > Settings.
4. Select the Admin tab.
5. Clear the Require clinical log on check box.
6. Click Save.
7. Restart the service tool.
Note This setting takes effect only after the service tool
restarts.