Welch Allyn CardioPerfect Workstation Resting ECG Module - User Manual - Manual (Page 37)

CardioPerfect Workstation
Resting ECG Module - User Manual
DIR 80012333 Ver. E 37 / 54
2. Remove the battery.
3. Insert a new 9V alkaline battery.
4. Click the lid back into place.
Caution
Please observe the following:
We advise you not to use rechargeable batteries, because their voltage
can drop steeply without warning. This can stop the ECG monitoring
during a test.
The Welch Allyn CardioPerfect Pro recorders
The Welch Allyn CardioPerfect Pro recorders get their power either via a USB connection or via a
rechargeable battery. If a USB-Prolink is used, the Welch Allyn CardioPerfect Pro recorder gets
it‟s power from the USB port of the computer, the battery pack supplied with the recorder is then
a so-called dummy.
If the recorder is connected to the computer by means of an RS232 Prolink, the power is supplied
by a battery-pack in the bottom of the recorder, this battery pack needs to be recharged (charger
is supplied with the system) when the indicator turns red.
Caution
If the recorder is powered from the USB port, but also has a battery
pack, this battery will be drained slowly as well and if the recorder
detects an empty battery it will not function until the battery is recharged
or removed.
After you have replaced or charged (Pro) the batteries, let the Welch Allyn Cardio Perfect
software run in Monitor mode for a few seconds. This verifies that the recorder functions properly
and the optical cable is undamaged.
To charge the battery of the Welch Allyn Pro Recorder:
The battery compartment is located at the bottom of the unit.
1. Pull the battery compartment from the recorder by holding the Welch Allyn Cardio Perfect
Pro recorder with one hand and pressing on both sides off the battery compartment with