Vinten Radamec ICE Tool - Manual (Page 7)

5
PC Ethernet Connections
The computer installed with ICE Tool is connected to ICE robotic
devices using an Ethernet connection. This can be in two different
configurations:
.
This is useful to configure a new device such as a robotic head in
isolation from a control system.
This gives access to all of the ICE devices within a system, but still
gives the flexibility to configure individual devices. Each ICE device in
a system is assigned a unique IP address.
1
Directly to one device - Direct Ethernet connection between
the PC and one ICE robotic device.
OR
2
Across a robotic system to many devices - Ethernet
connection between the PC and a control system via a router
or network.
Note
ICE Tool can be installed onto a VRC or LCS controller
computer and used to connect to any ICE device in the
system.
OR