Vintage Cellars Transtherm Double Ermitage Solid Door Black - Manual (Page 13)

13
GB
A
Lighting mode
B
Open door alarm
C
Temperature zones concerned
D
Sensor fault alarm
E
Temperature alarm
F
Confirmation and setting access key
G
Setting and selection keys
H
Lighting mode access and confirmation key
I
Standby key
J
Display of the temperature on the top of the cabinet
K
Hot circuit in-use indicator
L
Cold circuit in-use indicator
M
Display of the temperature on the bottom
of the cabinet
III-C. Temperature setting (multi-temperatures model)
Recommended temperature setting range for the lowest temperature: 7 - 9 °C / 45°F - 48°F.
Recommended temperature setting range for the highest temperature: 17 - 20 °C / 63°F - 68°F.
• For the lowest temperature, the default setting is 8°C / 46°F. However
you can set the temperature between 6 - 12°C / 43 - 54°F.
• For the highest temperature, the default setting is 18 °C / 64°F.
• However you can set the temperature between 15 - 20 °C / 59 - 68°F.
N.B: in order to operate correctly, your cabinet must be
placed in a room with a temperature of 12 - 35 °C / 54 - 95°F.
The value shown on the display is the actual temperature inside
the cabinet. It is therefore necessary to wait before your new
setting takes effect.
The tactile keys are very sensitive.
There is no need to apply force, a light
touch is sufficient to register the
command. Remember to remove your
finger from the panel between presses.
II-C. Description (multi-temperatures model: Réserve)
3
Press the button to confirm.
The right-hand display will flash.
4
Press the or keys to set the desired temperature.
5
Press the button to confirm.
2
Press the or keys to set the desired temperature.
Press and hold down the key for 5 secs to power up.
1
Press and hold down the key for approximately 5 secs.
The display will start to flash.
M L
C E D C B A F G H
K J I
5 sec.
6 - c
ommissioning your Wine cABinet