Universal Remote Control (URS) RFS200 - Manual (Page 8)

13 14
BASIC SETUP
BASIC SETUP
Pre-Programmed Code Method
Pre-Programmed Code Methoda
STEP 9:
Once you have found the right code, save
the code number by pressing the SAVE
display button that appears on the LCD
screen. The LCD screen will blink
“SAVED” two times, signaling that the
code number has been successfully
saved.
STEP 10 :
Exit SETUP mode by pressing the MAIN
button two times.
When the LCD screen displays MAIN, you
are back in normal operating mode.
NOW, PROGRAM THE REST OF YOUR
COMPONENTS BY REPEATING STEPS 1
THROUGH 9. IN MOST SYSTEMS,YOU
CAN FINISH BASIC SETUP IN JUST A
FEW MINUTES AND PUT ALL YOUR OLD
REMOTES AWAY.
IF YOU ARE STILL MISSING COMMANDS
TO CONTROL ANY OF YOUR COMPO-
NENTS, USE THE LEARNING METHOD
ON PAGE 15.
SAVE
BUTTON
MAIN
BUTTON