Customizing – Universal Remote Control (URS) RFS200 User Manual

Page 15

CUSTOMIZING

STEP 7:

Press the second component display
button that you want the Macro to turn on
(in this example, VCR) and “VCR” will
display at the top of the screen. (“STEP 4”
will display at the bottom of the screen.)

STEP 8:

Then, press the ON button to confirm the
command. (“STEP 5” will display at the
bottom of the screen.)

STEP 9:

Now, press the MAIN button to return to
the Main Component listing. (“STEP 6” will
display at the bottom of the screen.)

STEP 10:

Press the third component display button
that you want the Macro to turn on (in this
example, CABLE) and “CABLE” will
display at the top of the screen.
(“STEP 7” will display at the bottom of the
screen.)

STEP 11:

Then, press the ON button to confirm
the command. (“STEP 8” will display at
the bottom of the screen.)

You can also program delays in
between commands by pressing the
(II) PAUSE button. Each press adds half
a second to the delay.

STEP 12:

Press the LIGHT button to end your macro.
A new screen will appear:

STEP 13:

If you are satisfied with your macro, press
the SAVE display button. The UNDO
display button lets you erase the last step.
The EXIT display button erases all the
macro steps.

STEP 14:

Press the MAIN button twice to return to
normal operation.

NOTE : Don’t worry about the number of steps.
Each macro button can store up to 190 steps,
so you are not likely to run out of steps!

MacroPower

™

Setup

MacroPower

™
Setup

SAVE

BUTTON

UNDO

BUTTON

EXIT

BUTTON