Universal Remote Control (URS) RFS200 - Manual (Page 11)

19 20
BASIC SETUP
CUSTOMIZING
Transmitting (Busy Signal) Icon
Customizing the LCD Screen Transmitting (Busy Signal) Icon
When a command is being transmitted, an icon will appear in the upper right corner of the
LCD screen. This indicates that a signal is being sent. This is particularly useful when
setting up Macros and FAVs, since it flashes with every step of a sequence of commands.
Customizing Your RF20 with Special Advanced Features
After you’ve finished all your basic setup, you can choose to make operation easier by
customizing the RF20 just the way you want, using the Special Advanced Setup Features
described in this section.
Customizing the LCD Screen
You can easily edit or change the name of any of the display buttons (including Favorite
Channels) on the LCD screen by following these steps:
CHILD LOCK FEATURE
This ‘child-lock’ feature prevents the unauthorized use of the remote control by
children. It blocks all operations of the remote control.
To Activate:
Press the +10 and ENT (Enter) buttons simultaneously for 3 seconds. The bottom of
the LCD will blink “LOCKED” three times and then display “LOCKED”.
To Return to Normal Operation:
Press the +10 and ENT (Enter) buttons simultaneously again for 3 seconds. The LCD
will display the last use mode.
STEP 1:
Press and hold the MAIN and ENT (Enter)
buttons at the same time for approximately
3 seconds, until the word “SETUP” is
displayed at the top of the LCD screen.
This signals that you are now in setup
mode.
STEP 2:
Press the EDIT display button.
The LCD display will change to the EDIT
menu.
STEP 3:
Press the TEXT display button.
The screen will display the list of
Components and “EDIT” will appear at
the top of the screen.
STEP 4:
Navigate to the Component and page
where there is a button label you want to
EDIT, selecting between the FAV, MAIN,
COMPONENT display buttons; then using
the PAGE button.
IMPORTANT:You now have 30 seconds to per-
form the next step while you are in SETUP
mode. If you don’t press a button within 30 sec-
onds, SETUP will disappear from the screen,
signaling that you have exited setup mode and
you will need to start over.
NOTE: If you wish to change the name of
a Component button, press the Page (
) Up
button twice. The top of the display will
change to MAIN, and you can navi-
gate to MAIN page 1 or page 2 before
going on to Step 5.