Universal Remote Control (URS) RFS200 - Manual (Page 17)

31 32
CUSTOMIZING
CUSTOMIZING
SimpleSound Setup &
Other "Punch Throughs"
Setting Backlight Options
The bottom of the display flashes
“PUNCH TO”. Press the button for the
Component that doesn’t have volume
control commands yet (i.e.,DVD). This is
the Component you are going to PUNCH
TO for the volume and mute commands.
STEP 5:
The bottom of the display will then flash
“PUNCH FROM”. Now select the
Component that has the volume com-
mands you want to use (i.e.,TV for sys-
tems using the TV speakers, AUDIO for
systems with surround sound receivers).
The bottom of the display will flash
“SAVED”.
STEP 6:
Repeat STEPS 4-5 until all your
Components operate the volume perfectly.
STEP 7:
Press the MAIN button twice to return to
normal operating mode and test your
SimpleSound™ settings.
Simply perform the steps outlined above,
but in STEP 4, press one of the control
options (CH, PLAY or VOD).
NOTE: If you want to PUNCH TO the MAIN
Component, press the POWER OFF button at
this time.
NOTE: The Punch Through feature is not limited to
volume and can also be applied to channel selection
or other functions. If you find yourself switching to a
particular Component frequently to use a group of
controls, consider using Punch Through for another
group, as listed here:
VOL Volume Up,Volume Down and Mute
CH Channel Up, Channel Down, Previous Ch
and Channel (0-9) buttons.
PLAY Play, Stop, Pause, Rewind and Fast Forward
VOD Guide, Menu, Info, Exit, Up, Down, Left,
Right, Select
Setting Backlight Options
You can customize the backlighting feature to suit your specific preferences by fol-
lowing these simple steps:
Adjusting Length of Backlight Time
You can adjust the amount of time that the RF20 backlight stays on by entering the
SETUP mode and proceeding to page 2 (using the PAGE ( ) UP button), then pressing
the LIGHT display button on the LCD screen (not the Backlight button). Then enter the
amount of time you would like the light to stay on using the number pad (0-99 sec-
onds). After making your selection, press the SAVE display button.
Adjusting Contrast
You can make the text darker by pressing both the MAIN and cursor UP buttons at the
same time. To make the text appear lighter, press both the MAIN and cursor DOWN
buttons at the same time.
Turning OFF Backlighting
If you don’t want backlighting at all (this extends battery life), press the ON display but-
ton that appears on the screen. The ON will change to OFF. Press the SAVE display
button. Exit the setup mode by pressing the MAIN button.
MAIN
BUTTON
UP & DOWN
CURSOR
HIGH
CONTRAST
LOW
CONTRAST