Basic setup – Universal Remote Control (URS) RFS200 User Manual

Page 10

BASIC SETUP

Learning Method

STEP 5:

Press any button on the RF20 that you
want to teach a command to. The top of
the screen will change to “READY” and
the bottom of the screen will display the
button name you pressed.

STEP 6:

Press and hold the button on the other
remote control that you want to ‘teach’ to
the RF20 until the LCD display on the RF20
changes to either “GOOD” or “FAILD”. If
the “GOOD” label appears on top of the
display, you were successful. If the
“FAILD” label appears on top of the display,
try ‘teaching’ thesame button to the RF20
once again by repeating STEPS 5 and 6.

STEP 7:

Now, continue to teach the RF20 any other
commands from your other remotes by
repeating STEPS 4 through 6 (to go back
to STEP 4, simply press MAIN once).

STEP 8:

Once you have completed teaching all the
button commands to the RF20, return to
normal operation by pressing the MAIN
button twice.

• Move to another room. Plasma TVs, sun-

light, halogen or quartz lighting can inter-
fere with the learning process.

• Even though the old remote seems to be

working fine, put in fresh alkaline
batteries.

• Gradually vary the distance between the

remote controls.

Try 1”, 2” and so on, up to 4 feet.

• Try tapping the button on your old remote

instead of pressing and holding it during
the learning process.

Some additional Information regarding the
Learning Process:

• Learned functions override any existing

pre-programmed functions on the
remote control.

• All buttons can be learned except for the

PAGE, MAIN and LIGHT buttons.

• Learned functions are automatically

erased when a new function is learned
on the same button.

• Learned functions are retained even

after a different Setup Code Number is
programmed into the remote.

• To return to an original pre-programmed

function, a learned function must be
erased.

NOTE: If you don't see the display button you
would like to teach on the LCD screen, use the
PAGE ( ) ( ) buttons. The only buttons you
can't teach are the PAGE and MAIN buttons.

NOTE: Test all your new commands. If any of them
don’t work, try the Learning Method again, follow-
ing these suggestions: