Universal Remote Control (URS) UR4-DSR - Manual

Universal Remote Control, Inc.
www.universalremote.com
OEE-0050B Rev 06 (02/06/07)
UR4-DSR
Operating Instructions
For 4 in 1
SAT Remote Control
The remote control is designed to
operate the Motorola
DSR400 Series
Digital Receiver. You can also control
the majority of TV, VCR/DVD and AUDIO
equipment on the market as shown
below.
SAT : Satellite Receiver
TV : Televisions
VCR : VCRs and DVD
AUX : Audio Receivers, DMX & DCR,
TIVO, etc.
Introduction 1
Replacing Batteries 2
Default State :
Device Default: Motorola DSR400 Series.
Channel Default: SAT channel and number keys through the SAT, with the option of controlling
channel and number keys through the TV or VCR. Refer to section F for programming the
channel and number keys through your TV or VCR.
Volume Default : SAT volume and mute through the TV , with the option of controlling volume
and mute through the SAT or AUDIO.
Refer to section G for programming the volume and mute through your SAT or AUDIO.
System On/Off button :
This button is designed to send out power commands for two, three or all four devices with one
button press. Please refer to section E for details.
Button Functions 3
Before you program or operate the
remote control, you must install two
new AAA alkaline batteries.
STEP1 Remove the battery compartment
cover on the back of your remote
control.
STEP2 Check battery polarity carefully,
and install the batteries as
shown in the illustration below.
STEP3 Replace the battery compartment
cover.