Rice Lake WeighVault for Counterpart - Manual (Page 3)

SCALES FEATUR PFORMT VERS
XXXXXXX ID ACCUM DISPLAY TEST SETUP AUDIT CALIBR
CONFIG
DIGI/O SERIAL ETHERNET
DHCP
NET MASK
DFLTGTWY
PORT
LC LMSTNM
DNSPRI
REMOTE IP
REMOTE PT
MAC
IP ADDRESS
VAULT
DNSSEC
3
Configuring the Counterpart
1. From the SETUP menu, navigate to CONFIG » ETHERNET.
2. Configure the ETHERNET menu’s parameters as shown in Table 1.
Figure 4. Counterpart’s ETHERNET menu
Table 1. ETHERNET menu parameters and selections
Parameter Description Selection
DHCP Dynamic Host Control Protocol OFF (consult with network administrator)
IP ADDRESS Assigns an IP address to the Counterpart Set to an available static IP address
(consult with network administrator)
NET MASK Sets a subnet mask, if necessary 255.255.255.0 (consult with network administrator)
DFLTGTWY Sets the default gateway, if necessary Consult with network administrator
DNSPRI Primary DNS, if necessary Consult with network administrator
DNSSEC Secondary DNS, if necessary Consult with network administrator
LC LMSTNM LCL name Consult with network administrator
PORT Port number Port 10001
REMOTE IP Remote IP address IP address of the server/computer running WeighVault
REMOTE PT Remote port 5466
MAC MAC address Addres of Ethernet (not changeable)
VAULT Enable WeighVault Set to ONBOARD to use the Counterpart ’s onboard
Ethernet connection. Set to EXTERNAL to use the WLAN
option card (if installed)