Rice Lake WeighVault for Counterpart - Manual (Page 2)

2 WeighVault Installation Instructions
Installation
Setting up WLAN Options
NOTE: For detailed instructions, refer to the manuals supplied
with the option kits. Perform the installation at an ESD-safe
workstation.
1. Disconnect the indicator from its power
source.
2. Remove the back cover from the indicator.
3. Remove the option cover plate.
4. Remove the WLAN option card from its ESD
bag.
5. If installing WLAN, carefully screw the
included antenna onto the white RF cable on
the cover plate. In addition, set the WiPt/Xcvr
switch to the Xcvr position, and place both
CFG/LOOP jumpers in the CFG position.
6. Install the 2 plastic standoffs into the two holes
o n t h e i n d i c a t o r ' s C P U b o a r d l o c a t e d
approximately 1.5 inches to the left of J5.
7. Carefully align the Ethernet / WLAN option
card connector with the J14 COMM-OPTION
connector on the indicator's CPU board. Press
down to seat the card in the connector and the
two standoffs.
8. If installing WLAN, the antenna is on the
cover plate. In washdown environments, we
recommend the antenna joint not be exposed to
the environment as the product may become
t r a p p e d i n t h e j o i n t . I n n o n - w a s h d o w n
applications, the joint should be exposed and
positioned to follow the travel of the indicator's
tilt direction.
9. Hardware installation is complete. Do not
install the indicator's cover until configuration
is complete.
WeighVault service and editor installation
1. Insert the WeighVault DVD (PN 125546).
2. Click Install WeighVault Service for 32-bit or
64-bit, depending on your system type.
3. Follow the on-screen steps until you reach the
Database Installer shown in Figure 2.
Figure 2. Database Installer screen (disconnected)
4. Click Connect .
5. When the status changes from Disconnected to
Connected, click Go.
Figure 3. Database Installer screen (connected)
6. Upon successful installation, click Close .
7. Click Install WeighVault Editor for 32-bit or 64-bit,
depending on your system.
8. Follow the steps until installation is complete;
then, click Close .
9. Restart your PC.
Note
Computer must be restarted for the WeighVault
service to load.