Rice Lake Tracer AVi - v2.0 - Manual (Page 16)

12 Tracer AVi Installation Manual
3.2 VIRTUI Configuration
VIRTUi can be used to set iQube configuration parameters. When configuration is complete, data is downloaded
to the iQube .
To configure the iQube using VIRTUi :
1. With the PC and iQube connected and the VIRTUi program running, select iQube Configuration from the
Settings menu.
Figure 3-10. VIRTUi Tracer AVi Display
2. Select the Cells display. Use this display to select the load cell used in the Tracer AVi system by checking
the box to the left of the cell. Enter load cell data such as factory sensitivity, serial number, and capacity
on the General Information sheet for the cell.
3. Select the Platforms display. The cell that was checked on the Cells screen is now listed as Available
Load Cell for the iQube .
4. Click on Platform 1 .
5. Double-click on the load cell to move the cell into the Assigned Load Cell column for Platform 1.
As the cell is added to the Assigned Cell column, a Section Format Diagram is displayed at the bottom of
the screen.
6. Select the Systems display.
7. Click on System 1 .
8. Platform 1 is now shown in the Assigned Platforms field. Click the Platform 1 box to assign Platform 1 to
System 1. Use the General display to enter scale system parameters.
3.2.1 Downloading to the Tracer AVi
Once configuration is complete, you must download the configuration data from the PC to the iQube .
1. Select Send Configuration to write the values to the iQube .
2. Click Begin to initiate the download. Downloading may take up to 30 seconds.