Rice Lake RL1200 Portable Beam Scale - Manual (Page 13)

Setting Up Your Scale 9
6. Place the beam cap assembly over the weight rack (facing same direction as hook and steelyard hook) using
acorn bolts and washers and snug the beam cap assembly.
Figure 2-12. Attach Beam Cap Assembly
7. Attach the two loop clamps onto beam assembly.
Attach loop clamp (as
shown)
Second loop clamp
attaches here fac-
ing upwards (also
see Figure 2-14)
Figure 2-13. Attach Loop Clamps to Beam Assembly
8. Take the beam assembly and put the upper end of the steelyard rod through the lower loop clamp on the beam
and hook the upper loop clamp to the hook on the weight rack (not shown).
Hook the steelyard upper
hook through the lower
loop clamp as shown.
Hook the
upper loop
clamp to the
weight rack
hook (not
shown)
Figure 2-14. Hook Loop Clamps to Beam Assembly and Weight Rack