Rice Lake RS-130 - Operation Manual - Manual (Page 5)

Introduction 1
About This Manual
This manual contains operating procedures for the
RS-130
retail scale and provides you with all the
information necessary for setup and operation.
This manual is organized based on the procedures you
will likely follow when setting up and using your
retail scale.
When using this manual, front panel keys are shown
in
BOLD
characters.
A u t h o r i z e d d i s t r i b u t o r s a n d t h e i r
employees can view or download this
manual from the Rice Lake Weighing
S y s t e m s r e t a i l d i s t r i b u t o r s i t e a t
www.ricelakeretail.com
.
1.0 Introduction
The
RS-130
retail scale offers practical solutions for a
full range of point-of-sale weighing and price
computing applications. Its compact design makes it
easy to transport and the customer display on the rear
of the
RS-130
offers extra convenience.
Standard features of the
RS-130
include:
• NTEP-certified Legal-for-Trade
• Measurement Canada approved
• Customer display on rear of unit
• Operates on 110 VAC or 6V internal battery
• Configurable for lb, kg or oz (oz not available
in Canada)
• Calculates customer change
1.1 Start-up Self Check
the
RS-130
must charge for 24 hours prior to
operation. When you turn on the scale with the
ON/
OFF
switch, which is located on the bottom of the
scale, the main program provides the following
display check. The display turns on and shows the
total capacity in the WEIGHT display. Counts from
one to nine in each display window, displays the total
capacity in the WEIGHT display again, and displays
0.00
for operation.
1.2 Power Supply
The
RS-130
can use power supplied by either a plug-in
110VAC or the internal sealed, lead-acid rechargeable
battery with a life expectancy of five years under
normal use.
• AC - 110V/60Hz ±10% (battery recharging
only)
• DC - 6V / 25mA; P=0.2W (max) 4Ah
1.3 Battery Recharging
The battery has 100+ hours of use before it needs
recharging. When the battery is low, the TOTAL $
display shows
-LO-
and there is a continuous beep.
Press the
CLEAR
key to remove
-LO-
and end the beep.
After the initial warning of low battery, the scale has
approximately two to three hours of battery life left.
Every 30 minutes a beep sounds and TOTAL $ display
shows
-LO-.
If the battery is not charged, the TOTAL $
display shows
-OFF-
and the scale beeps continuously.
Turn the scale off and recharge the battery. Allow
eight to ten hours to fully charge. Table 1-1 describes
the meaning of the Charge LED colors.
Table 1-1. Battery Charge LED’s
LED Color Description
Red Initial connection
Orange Charging
Green Fully-charged
1.4 Setting the Auto-Off Feature
Note
Work inside scale enclosure is not required.
1. Turn on the scale while pressing the
CHANGE
key until
6.3
(version) shows in the WEIGHT
display (approximately three seconds).
2. Press and hold the
ZERO
key until the
WEIGHT display shows
SEtUP
(approx. three
seconds).
3. Press the
3
key, WEIGHT display shows
USUAL
.
4. Press the
2
key to enter the Auto-Off mode.
WEIGHT display shows
-OFF-
.
5. Use the
CLEAR
key to select
-30-, -15-, -5-,
-OFF-.
6. Press the
CHANGE
key to confirm setting.
Scale will automatically restart.