Rice Lake Remote Displays/Scoreboards - 234HE - Manual (Page 5)

4
Switch #1--Data Transfer Rate
(F 1.5 Series EPROM Version)
(Series 1, 2, or 3 EPROM Version)
off 1200 BAUD off 300 BAUD
on 2400 BAUD on 1200 BAUD
Switch #2--Number of Data Bits
off 7 data bits
on 8 data bits
Switch #3--Number of Stop Bits
off 1 stop bit
on 2 stop bits
Switch #4--Odd Parity
off no parity or parity disabled
on odd / even parity enabled
Switch #5 and #6--Serial Input Format
5 off 6 on 20 mA Current Loop
5 on 6 off RS232C
Switch #7--Time Display (Unavailable Option)
off time display disabled
on time display enabled
Switch #8--Temperature Display (Unavailalble Option)
off temperature display disabled
on temperature display enabled
3. Configuration of Dip Switches
The purpose of dip switches #1-#6 is to ensure that the remote display and the indicator
are communicating in the same format. Consult your indicator manual to find the indicator's
current configuration. Check that the correct EPROM has been installed. Disconnect power
and set switches 1-6. Switches #7 and #8 enable the time and temperature display if those
options are installed.