Rice Lake Ranger Count 3000 Series, Ohaus - Manual (Page 21)

Ranger™ Count 3000
Series EN-19
4.6 Print1 Menu
Enter this menu to set printing parameters. Default settings are in bold.
Note:
The Print2 menu is only displayed if a second interface is installed.
Reset
[reset]
Reset the Print menu to factory defaults.
NO = no reset
YES = reset
Stable Only
[Stable]
Set the printing criteria.
OFF = values are printed immediately
ON = values are only printed when the stability criteria are met
Auto Print
[A.Print]
Set the automatic printing functionality.
OFF = disabled
ON.STAB = printing occurs each time the stability criteria are met
INTER = printing occurs at the defined interval
CONT = printing occurs continuously
ACCEPT = printing occurs each time the display is within the Checkweigh accept
range and stability criteria are met.
Content
[CONtNt]
Define the content of the printed data.
Part Number
Set the status.
OFF = disabled
ON = enabled (The part or SKU number set up in Library will be printed)
Note:
See section 3.7 for how to enter part or SKU number.
Reset:
no
, yes
Stable Only:
off
, on
Auto Print:
off
, on stable, interval, continuous, accept
Content: P/N (-> off, on)
Result (-> off, on)
Gross (-> off, on)
Net (-> off, on)
Tare (-> off, on)
Header (-> off, on)
Footer (-> off, on)
Mode (-> off, on)
Unit (-> off, on)
Info (-> off, on)
APW (-> off, on)
Acc (-> off, result, all)
Layout: Format (->S,M)
Feed (->Line, 4 Lines, form)
Data Transfer: off, on
Print Lib: yes, no
End Print: Exit menu