Rice Lake Star SP298 Series Programmers Manual - Manual (Page 59)

56
3) N=2
n1 :Always “0”
n2 :Always “0”
n3 :Always “0”
n4 :Always “0”
4) N=3 (Star mode only)
n1 :Always “0”
n3 :Always “0”
(Default)
5) N=4 (Star mode)
n3 :Always “0”
n4 :Always “0”
(Default)
N=4 (ESC/POS mode)
n1 :Always “0”
(Default)
Parameter Setting “ 0 ” “ 1 ” “ 2 ” “ 3 ”
n2 Character table See below
n4 CR code Invalid Invalid Valid Valid
n2 Character table n2 Character table n2 Character table
“0” Normal “4” Code page 858 “8” Code page 863
“1” Katakana “5” Code page 852 “9” Code page 865
“2” IBM (Code page 437) “6” Code page 860 “A” Code page 866
“3” IBM (Code page 437) “7” Code page 861
Parameter Setting
“
0
” “
1
” “
2
” “
3
”
n1 X on/X off Timing When
Toggled every 3
sec When
Toggled every 3
sec
RTS Signal Condition Save as
DTR Save as
DTR always
SPACE always
SPACE
n2 Receive buffer size 2k bytes 2k bytes 35 bytes 35 bytes
Parameter Setting “ 0 ” “ 1 ” “ 2 ” “ 3 ”
n2 Receive buffer size 512 bytes
(TM-295)
2k bytes
(TM-290)
512 bytes
(TM-295)
2k bytes
(TM-290)
35 bytes 35 bytes
n3 DSR signal check
during setting status
transmission
Checked Checked
Not
checked
Not
checked
n4 Data receipt error "?"
printed
Ignored "?"
printed
Ignored