Rice Lake Datamax M-Class Mark II - Manual (Page 59)

Chapter 5 – Maintenance and Adjustments 53
5 5 5 . . . 8 8 8 R R R e e e s s s e e e t t t t t t i i i n n n g g g t t t h h h e e e P P P r r r i i i n n n t t t e e e r r r
Depending upon the method used, there are three reset levels possible:
Soft Reset - To reset the printer and clear any temporary host settings:
1. With the printer ‘On’, press and hold the PAUSE and CANCEL buttons for approximately
four seconds.
Level One Reset - To return the printer to the factory default settings or, if saved, to restore
the Factory Setting File:
1. Turn ‘Off’ the printer.
2. Turn on the printer, when the three lights turn on press and hold the PAUSE and CANCEL
Keys; continue to depress the keys until the ‘READY’ message or Ready light appears.
;
This reset has the same effect as the System Settings / Set Factory Defaults selection
in the menu system.
Level Two Reset - To return the printer to the factory default settings, and clear all the
calibration and adjustment parameters:
1. Turn ‘Off’ the printer.
2. Turn on the printer, when the three lights turn on press and hold the PAUSE, FEED, and
CANCEL Keys; continue to depress the keys until the ‘READY’ message or Ready light
appears.
;
After executing a Level 2 Reset, the media calibration must be performed; see Section
3.5.