Rice Lake Portable Bariatric Wheelchair Scale Single Ramp (350-5) - Rice Lake Bariatric Wheelchair Scale - Manual (Page 15)

Bariatric Wheelchair Technical and Operating Manual - Scale Configuration 11
5.0 Scale Configuration
Options and parameter setup are done through the scale configuration section and is used for setting values and
various parameters and options that are essential for the functioning of the system. Entry into this mode is
possible only when the scale is turned off.
Enabling Configuration or Calibration Modes
Before the scale will enter either the Configuration or Calibration mode, the configuration enable jumper must be
removed.
Access to that jumper is gained by removing the back cover of the indicator. Remove the four back cover
retaining screws as shown on the left side of Figure 5-1. With the cover removed, the jumper can be seen sticking
through the hole in the rear housing (shown in Figure 5-1 - right side). Remove that jumper to gain access to the
Configuration and Calibration modes.
Remove retaining screws x 4 (only 2 shown)
R e m o v e j u m p e r t o g a i n a c c e s s t o
configuration and calibration modes
Figure 5-1. Gain Access to the Configuration/Calibration Enable Jumper on the Back of the Indicator
After configuration or calibration is done, the jumper must be replaced for normal scale operation.
NOTE: A display of Con En indicates that the jumper is not in place. Put jumper on both pins to return the scale to
normal weigh mode.
Configuration Mode
To get into the configuration mode, turn the scale off and remove the configuration jumper as shown in
Figure 5-1. Turn the scale on. While
Start
is displayed, press and hold the
Kg-Lb
key until
IDENT
appears on the
display.
To change from one parameter to the next, press the
REWEIGH
key once.
To change the value of the parameter, use the
Kg-Lb
key.
From the
SAVE
phase: to save the configuration data, press the
REWEIGH
key.
DONE
appears for one or two
seconds followed by
Start
and the display enter into weighing mode and is ready to start the weighing process. To
exit with saving changes, press the
Lb/Kg
key.