Rice Lake Portable Bariatric Wheelchair Scale Single Ramp (350-5) - Rice Lake Bariatric Wheelchair Scale - Manual (Page 10)

6 Bariatric Wheelchair Technical and Operating Manual
3. Figure 3-3 illustrates where the load cell connection point is located.
Load Cell Connection Point
Figure 3-3. Load Cell Connection Point
Plug the end of the load cell cable into the load cell connection point shown in Figure 3-3. You will hear a "click"
when the load cell cable has been properly seated into the connection point.
Replace the back cover on the indicator with the four back retaining screws and re-attach to the tilt stand.
3.2 AC Power Connections
The Rice Lake Bariatric Wheelchair Scale has a 120 VAC adaptor or 230 VAC adaptor to use when power is
readily available. The AC power adaptor plugs into the back of the indicator as shown in Figure 3-4.
Connect the AC power
source here
L E D i n d i c a t o r l i g h t
illuminates from red to
green when charged
Store the 120 VAC
adaptor here when
not in use
RS-232 port
connection
Store the 230 VAC
adaptor here when
not in use
Back cover to
indicator
Figure 3-4. LED Light Location
The AC adaptor, when not in use, plugs into the back housing of the indicator. Figure 3-4 shows that location.
The Rice Lake Bariatric Wheelchair Scale is capable of running its internal sealed lead-acid rechargeable battery
if no additional power source is available. Battery life is approximately 75 hours. If the
LO Bat
indicator is
showing on the display, recharge the battery or connect the scale to an AC power source as soon as possible for
accurate weighing.