beautypg.com

Initiating data transfer at the scales – Rice Lake Ishida AstraLabel User Guide User Manual

Page 17

background image

13

6. Initiating Data Transfer at the Scales

The following describes the procedure for initiating data transfer at the scales for an AC-3000
series scale. The procedure is different for different scales models. Refer to the Ishida
documentation for the correct procedure for the scales you are using.

1.

Set the scales to TEST mode.

2.

Select DATA SAVE/LOAD (99).

3.

Select TRANSFER FILE (2).

4.

Enter the IF21 FILE NO.

If receiving label data from the scales

5.

Select SEND, LABEL FORMAT (4).

6.

Press the PRINT button.

7.

The scales display indicates when data transfer has completed.

If transmitting a label to the scales

5.

Select RECEIVE, LABEL FORMAT (4).

6.

To set the new label in a slot other than slot 0, enter the slot number (but do
not press enter).

7.

Press the PRINT button.

8.

The scales display indicates when data transfer has completed.

See also other documents in the category Rice Lake Scales: