Rice Lake Intercomp SW™ Deluxe Portable Vehicle Scale - Manual (Page 16)

SW Users
Rev G, February, 2000
16
1. Press ENTER to enter the features menu.
2. Select #2 to start Vertical CG.
3. Have the car level with the ground.
4. Enter the wheel base (refer to the center of gravity section above).
5. The scale will display the current CG.
6. The scale will ask you to raise the rear wheels.
7. Raise the back of the car and weigh pads. A good 'rule of thumb' is raise the
back one inch for each foot of wheel base.
8. Press Enter.
9. Enter the amount the back wheels were raised in tenths (which unit you use
inches, centimeters, etc.; doesn't matter the result will be in the same units).
10. The results will be displayed
Special Displays
Item #3 in the features menu is special displays, this choice allows you to
activate three alternate weight displays (see Appendix B for display screen
examples).
1. ACT, TGT, TUN
2. Sides
3. Bite
Act, Tgt, Tun
In this display mode the screen shows:
1. All four pads’ actual weights.
2. All four pads’ target weights.
3. All four pads’ tune weights.
Wheels and Sides
In this display mode the screen shows:
1. The actual weight of all four pads.
2. The wedge (LR+RF) as a percentage of the total weight.
3. The four sides as percentages of the total weight: Left, Right, Front,
Rear.
4. The total weight.
Sides and Bite
In this display mode the screen shows:
1. The wedge weight (LR+RF).
2. The four side weights: Left, Right, Front, Rear.
3. The front bite (LF-RF).
4. The rear bite (LR-RR).
5. The total weight.
Time and Date
When the SET TIME/DATE key is pressed the current time and date will be displayed.