Rice Lake Intercomp CS 1500 - Users Manual - Manual (Page 17)

CS1500, Users
Rev S, June, 2009
17
Calibration switch
The calibration of the scale is protected from accidental change by a shunt placed on
“CAL” (instead of “RUN”) of J8, located on the top/middle of the A/D 20 BIT circuit
board.
Enabling the Calibration
The shunt must be moved from “RUN” to “CAL”. When you are done calibrating,
place the shunt back on “RUN” to protect the calibration from change.
How to calibrate the scale
The following details the calibration procedure for the crane scale. There are eight
parameters that can be set without moving the calibration blocking switch, followed by
five more parameters and calibration that require the calibration blocking switch be in
the enabled position.
Step Display Parameter Note Default
4 ee-ee ee-ee ee-ee ee-ee Skip 0=no skip, 1=EE-10 EE-10 EE-10 EE-10, 2=LL-00 LL-00 LL-00 LL-00 0
5 EE-00 EE-00 EE-00 EE-00 Sample Rate 1 to 64 4
6 EE-01 EE-01 EE-01 EE-01 Update Rate 1 to 32 4
7 EE-02 EE-02 EE-02 EE-02 Demand Output 1=Yes, 0=Continuous 1
8 EE-03 EE-03 EE-03 EE-03 Baud Rate 0 to 9 0
9 EE-04 EE-04 EE-04 EE-04 Auto-off Time 0 to 255; 0=off 20
10 EE-05 EE-05 EE-05 EE-05 Power up in KG 1=kg, 0=lb 0
11 EE-06 EE-06 EE-06 EE-06 Tare Type 1=keyboard, 0=push-button 0
12 EE-07 EE-07 EE-07 EE-07 Sleep Mode Time 0 to 255; 0=off 5
13 ee-08 ee-08 ee-08 ee-08 Set Point 1 1 to 99999 99999
14 ee-09 ee-09 ee-09 ee-09 Set Point 2 1 to 99999 99999
Information saved
Check for calibration blocking switch
15 EE-10 EE-10 EE-10 EE-10 AZT 0=off,1=0.6,2=1,3=3 2
16 EE-11 EE-11 EE-11 EE-11 Zero Range 0=off,1=on 0
17 EE-12 EE-12 EE-12 EE-12 Canadian Specifications 0=off, 1=on 0
18 EE-13 EE-13 EE-13 EE-13 Initial Zero Range 0=off, 1=on 0
19 EE-14 EE-14 EE-14 EE-14 Graduation 0 to 11 6
20 Information saved
21 LL-00 LL-00 LL-00 LL-00 Zero read Enter capacity
22 LL-01 LL-01 LL-01 LL-01 First weight Enter first weight
23 LL-02 LL-02 LL-02 LL-02 Second weight Enter second weight
24 LL-03 LL-03 LL-03 LL-03 Third weight Enter third weight
25 Information saved
Start up
1. Move the calibration blocking switch to the “CAL” position if you intend to
calibrate.