Rice Lake GoDEX DT4 User Manual - Manual (Page 29)

DT2 / DT4 User Manual
27
5-2. Installing the cutter
1 Cutter module
2
1
2 Screws (set of 2)
【 Important 】
Remember to switch off the
printer before installing the
cutter.
【 Note 1 】
Do not use to cut adhesive
labels! Glue residue will be left
on the cutter blade and impair
its functioning. The cutter has a
blade life of 1,000,000 cuts
when using paper weighing up
to 120 g/m² and 500,000 cuts
when using paper weighing
between 120 g and 170 g/m².
【 Note 2 】
You can cut paper with a max. width of 114 mm.
【 Note 3 】
Labels should be at least 30 mm high (DT4).
(DT2: 40 mm)
【 Suggestion 】
During installation of the cutter, set the stop position in
Qlabel and/or in the driver to 30.
1. Place the printer on a flat
surface and open the
printer cover.
2. Remove the front cover.
3. Pass the cutter cable
through the opening as
shown in the illustration.
4.
Fit the label cutter in the
recess provided.