Rice Lake GoDEX DT4 User Manual - Manual (Page 26)

DT2 / DT4 User Manual
24
5. Accessories
5-1. Installing the label dispenser
1 Label dispenser
2
1
2 Screws (set of 2)
【 Note1 】 Remember to switch
off the printer before installing
the label dispenser.
【 Note 2 】 A label liner
thickness of 0.006 mm ± 10%
and a weight of 65 g/m
2
± 6%
are recommended.
【 Note3 】 The label dispenser
will take labels up to a max.
width of 110 mm (DT4) or 54
mm (DT2).
1. Place the printer on a flat
surface and open the
printer cover.
2. Remove the front cover.
【 Note 】
You can use a coin or
screwdriver to open the cover.
3. Pass the dispenser cable
through the opening as
shown in the illustration.
4.
Fit the label dispenser in
the recess provided.