Rice Lake Explorer Series Toploader, Ohaus - Manual (Page 145)

EXPLORER BALANCES EN-143
USB INPUT
The balance will respond to various commands sent via the interface adapter.
Terminate the following commands when with a [CR] or [CRLF].
Explorer Commands
?
print current mode
0A turn Auto-print off
SA Auto-print on, prints on stability
CA Continuous Auto-print
(n)A Auto-print on 1 to 3600 second intervals (n = 1 to 3600)
C perform span calibration
L perform linearity calibration
0M gram mode
1M ounce mode
2M troy ounce mode
3M pennyweight mode
4M parts counting mode
5M pound mode
T tare balance, same as pressing ON-ZERO
V print
software version
(Esc)R reset balance to factory defaults
P same as pressing PRINT
LE print last error code, i.e. [Err 0]
0S
print unstable data
1S print stable data only
P same as pressing Print
SP print stable weight only
IP immediate print of displayed weight (stable or unstable)
CP Continuous print of weights
SLP Auto-print stable non-zero weight only
SLZP Auto-print stable non-zero weight and zero reading
xP Auto-print on 1 to 3600 second intervals (x = 1 to 3600)
0P turns auto-print off
PM print current mode
M advance to the next enabled mode
PU print current unit
U
advance to the next enabled unit
T same as pressing Tare
Z same as pressing Zero
PV print software version
Auto-Print Operation
Once Auto-Print is activated in the menu, the balance will send data as required.
To temporarily stop Auto-Printing, press PRINT.
If there is data in the print buffer the printer will finish printing this data.
A second press will resume Auto-Printing.